FEATURES These gauges are for determining hole sizes in dies and all kinds of other work Quick, accurate measurement of hole and slot sizes Made of tempered steel with a locking device for fixing any leaf in position for use .500-1″ SPECIFICATIONS Range (in): .500-1″ Length (in): 2-3/4″ Number of Leaves: 10

These hole attachments make it possible to measure the inside of holes and other surfaces that cannot be reached with the regular indicator spindle. Both attachments have a 9.5mm (.375″) diameter hole to fit all indicators made to AGD standards and can be securely clamped to the indicator stem. The ball end on the swivel arm which contacts the work is 3mm (1/8″) in diameter. 14mm (9/16”) Range. FEATURES Range (Approx.) 14mm (9/16″) For Hole Depths to: 42mm (1-11/16″) SPECIFICATIONS Range (Approx.) 9/16″ 14mm

Ideal gage for checking bearing alignment or shaft deflection without dismantling the engine. Also useful as a strain gage on engine frames. This inside measuring gage checks the distortion of crankshaft webs and bears a direct relation to existing misalignment or excessive bearing wear. Used on all diesel engine shafts and center crankshafts on any type of engine or compressor, the gage can also be applied as a strain gage on engine frames while the engine is operating. A comparison of readings taken at top and bottom positions indicates any misalignment of cylinder and frame which results in local over-stress and eventual cracking of the frame neck. Gage with Balancing Attachment, 61-458mm Range neck. FEATURES The dial indicator movement is approximately 5/32″ (4mm) and with rods and extension, provides a range from 2 3/8-18″ or 61-458mm There are 10 rods and one extension furnished Rods are marked to designate the approximate overall length of the gage Indicator has a movable bezel to adjust the dial in relation to the hand and a non-breakable crystal Designed in collaboration with Hartford Steam Boiler. Gage is used by their inspectors to check the distortion of engine shafts and frames SPECIFICATIONS Type: Strain Gage Range (mm): 61 -458mm Graduations (mm): 0.02mm Dial Reading: 0-50-0 / 1mm Rev.

SKU The Starrett 98 Machinists Level with Ground and Graduated Vial includes a cross test vial. 300mm (12″) size, without case. FEATURES Ground and graduated main vials The base of the levels features an involute groove running the length of the base, which provides a reliable seat for round work The base of the levels features an involute groove running the length of the base, which provides a reliable seat for round work Cross test vial The vials are adjustable to a positive setting and are housed in a satin finished brass tube with a friction-fit closing cover to prevent breakage Main level vials have graduations that are approximately 80-90 seconds or .005″ per foot (0.42mm per meter) SPECIFICATIONS Length (in): 12″ Length (mm):300MM

The Starrett 98 Machinists Level with Ground and Graduated Vial includes a cross test vial. 150mm (6″) size, without case. FEATURES These levels have ground and graduated main vials The base of the levels features an involute groove running the length of the base, which provides a reliable seat for round work These vials are adjustable to a positive setting and are housed in a satin finished brass tube with a friction-fit closing cover to prevent breakage. SPECIFICATIONS Length (in): 6″ Length (mm):150MM